Contact Us Gallery New & Updated Parts
Search
Cart 0 item(s): $0.00
   
Catalog
Axle Parts
Body Parts
Books & Information
Brakes
Clutch / Trans / Drive Line
Door Parts
Electric / Ignition
Emblems
Engine / Fuel System
Exterior
Gifts & Toys
Interior
NOS Parts
Seals
Service / Operators Manuals / Literature
Sheet Metal
Steering & Suspension
Used Parts
 
Retainer - Bushing Used on larger International Trucks.
Valve Spring Retainer - New Old Stock
Model(s): 		Does your starter overheat or under crank? Our custom starter kit creates twice the torque of the original by use of a Denzo unit and aluminum housing.
Starter Motor- Aluminum High Torque
Model(s): 		This is the clutch cable for Scout 800 with manual transmission. Tired of grinding your gears due to a sloppy cable? Replace it with this factory part.
Clutch Control Cable
Model(s): 		933579R1
Snap Ring - New Old Stock 933579R1
Model(s):
Price: $47.03 each Price: $354.45 each Price: $148.29 each Price: $11.76 each
NEW OLD STOCK!!! The dip stick slides into this tube on a 152 & 196 engine.
Tube For Your Dip Stick On A 152cid IH Engine.
Model(s):
Thermostat Temp Sender - New Old Stock
Model(s): 		Valve New old stock
Valve - New Old Stock
Model(s): 		Make stater work every time. Are you tired of wondering if your Loadstar will start after you parked it in front of the in-law's house? :) Does your International truck or Loadstar periodically click when you turn the key. Mine sure does. I put in a new starter and a new battery and neither fixed the problem. We have figured out the problem. The wires are getting old and not sending a full 13.5 volts to the starter. This relay kit fixes this problem. The relay comes pre-wired for installation with labels on the wire. Most slow starting comes from aging of your wiring harness. This kit provides a clean clear maximum voltage directly from your battery to the starter. Kit includes: Starter relay and wiring harness. Step 1. Disconnect Battery. Step 2. All you have to do is, screw relay into firewall and attach 4 wires. Step 3. Attach relay and green wire to fire wall. Step 4. At the starter solenoid Attach the Red wire to the main big post that has the big wire that goes to the battery. Step 5. At the starter solenoid remove the white #17 wire and replace with the yellow wire. Step 6. Attach the blue wire to the existing white #17 wire that you just removed from the solenoid. You are done. This is what you do: Red wire goes to either battery or the big main terminal on the starter solenoid. yellow outputs full battery voltage to the "S" on the Starter solenoid. Not used -orange (if you have one) Blue wire connects to old starter wire Green wire must be grounded. This kit is not intended for use with 6 volt systems.
Starter Solenoid Relay - Fixes A Clicking Starter
Model(s):
Price: $75.32 each Price: $75.07 each Price: $112.68 each Price: $68.78 each
wiper motor New old stock. 682064R91
Wiper Motor - New Old Stock 682064R91
Model(s):
Emblem CO 1600 Loadstar - used
Model(s): 		all years of load star. V-190 trucks, Cab over A,B,C,
Driven Gear - NEW OLD STOCK
Model(s): 		3x1 INTERNATIONAL TRUCK LOGO ORANGE LOGO embroidered patch
International Badge Patch
Model(s):
Price: $657.29 each Price: $265.53 each Price: $47.20 each Price: $29.13 each

Accelerator Hinge Rod - New Old Stock
Model(s):
Rocker Valve Adjustable - New Old Stock
Model(s): 		Cargostar
Cable - New Old Stock
Model(s): 		If you have lost your dipstick, we have lots of new ones! This is a brand new oil level indicator for 266, 304, 345, and 392 motors. This fits all V8 engines that have the dipstick tube on the rear side of the engine. This will not fit engines that have the dipstick on the timing cover. This has been improved over the original unit, because the cap has been brazed on so it will never come loose and fall off again! Many times the old dipstick has fallen out; or the cap has disappeared so that oil is blowing all over your engine compartment. Not only is this messy, it means your PCV system is not working right, which can shorten the lifespan of your motor due to corrosion resulting from the inability of water vapor to be ventilated out of the motor. Why take chances on your $3000 motor for lack of a $23 part? Get one today! If you need the dipstick tube too, see <a href=\"http://www.scoutparts.com/products/?view=product&product_id=13577\">SP13577</a> or <a href=\"http://www.scoutparts.com/products/?view=product&product_id=13578\">SP13578</a>.
Oil Dipstick For IH V8 Engines
Model(s): 1700
Price: $151.09 each Price: $64.62 each Price: $228.62 each Price: $79.83 each

Bearing - New Old Stock
Model(s):
Fork Shift Fork - New Old Stock
Model(s): 		Loadstar 1972 and earlier. Price is for each rod.
Connecting Rods - New Old Stock
Model(s): 		this is a body mount for your Loadstar truck. New old stock
Body Mount Insulator Front Upper - Loadstar **Call For Availabilty**
Model(s):
Price: $58.67 each Price: $126.55 each Price: $232.24 each Price: No longer available

Loadstarparts.com is not affiliated with International Motor Company. Loadstar is a registered trademark of International Motor Company. Any mention of Loadstar is for description purposes only.

Call to Order: 866-235-1979
Credit Card Badges
Privacy Policy | Legal Notices | Terms & Conditions | Shipping Policy

A division of ©2025 Pacific Supply Group.