Model: 1800 Contact Us Gallery New & Updated Parts
Search
Cart 0 item(s): $0.00
   
Catalog
Axle Parts
Body Parts
Books & Information
Brakes
Clutch / Trans / Drive Line
Door Parts
Electric / Ignition
Emblems
Engine / Fuel System
Exterior
Gifts & Toys
Interior
NOS Parts
Seals
Service / Operators Manuals / Literature
Sheet Metal
Steering & Suspension
Used Parts
 
IH pilot bearings are in stock for the 3 speed and 4 speed transmissions. Pilot bearing noise is annoying, but can also damage your input shaft.
Pilot Bearing - New Production
Model(s): 1600, 1700, 1800 		This connector is compatible with all standard trailer and DOT approved commercial transportation wiring. If you are converting your tail lights to LED, do it right way with these, made in the USA, over molded terminal connectors that will insure that you never hook them up backwards. LED tail lights are very sensitive to how they are hooked up and this standard LED over molded connector insures that you will never have a problem. LED lights have a few differences from old incandescent light bulbs. This connector organizes your wires in such a way as to prevent any confusion. If you have installed your new LED tail lights, these connectors have to be added to your wiring harness. Once this is done, you are assured a weather and water resistant and reliable connection that only takes seconds. Made in the USA Bullet connector diameter is .155 inches in diameter. .155 diameter is the national standard for trailer and commercial transportation lights.
LED connector over mold for LED lights - Made in USA
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		These are OEM lap belts with mounting hardware.
Seat Belt - International
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Brand new clutch slave cylinder to fit the Travelalls and pickups from 1961 to 1968. It also fits some Metros. This comes with a new dust bellows. This will also work on Scout 800's with right hand drive. This slave cylinder was used on all models up to 1989 gas and Diesel.
Pick-up Clutch Slave Cylinder
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175...
Price: $33.03 each Price: $5.14 each Price: $227.93 each Price: $103.20

Bushing - New Old Stock
Model(s): 1600, 1700, 1800, 183RE 		Fits Loadstar with Prestolite electronic ignition.
Gold Box Ignition Module - Loadstar
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Center Bearing Loadstar 1700 and 1800 I.D. on this carrier bearing is about 1 - 3/4" The Screw that holds this in place is, FIL-HD 5/16NF X5/8th
Center Carrier Bearing Drive Shaft Support Bearing
Model(s): 1800 		Turn Signal assembly & hazard lights switch for larger trucks. LOADSTAR 1600 1700 1800. Compare the picture to yours before ordering. Made in the USA <img src=\"/images/usaflag-backed.gif\" />
Turn Signal Assembly & Hazard Lights Switch - LOADSTAR 1600 1700 1800 TURN SIGNAL
Model(s): 1600, 1700, 1800
Price: $64.62 each Price: $96.85 each Price: $460.84 each Price: $384.33 each
Wiring harness front head light and turn signals. Used on Loadstars built from 1972-79 <img src="/images/usaflag-backed.gif" /> Made in America. DISCONNECT BATTERY before doing any work. PLEASE READ BEFORE YOU ORDER: At least 40 years have passed since your machine was built. Many people have worked on, and changed things from factory configuration. It is customer's responsibility to make sure that harness and contact arrangement is correct for the application. Because the previous old harnesses may have damaged components in your electrical system, Pacific Supply Group accepts no liability for any device that you attach this new harness to. International Harvester wiring harness Loadstar
Loadstar Headlight wiring Harness 1972-79 424489C91
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Used but in perfect condition.
Vacuum Wiper Motor - near new
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		363433c91 New old stock turn signal switch. Seven wire turn signal switch with emergency switch.
loadstar Turn signal switch - 1972-1979 - 363433c91
Model(s): 1600, 1603, 1703, 1800, 1890 		377512C1. Gas or diesel fuels. This sender was used officially on Loadstars from 1972 to 79. It could have been used for previous years. But we do not know it will work on earlier Loadstars. It is most likely that the sender will work if you have a 1960's Loadstar as well.
Fuel Sender - New Old Stock Loadstar 1972-79, 377512C1
Model(s): 1600, 1603, 1610, 1700, 1800
Price: $266.77 each Price: $302.79 each Price: $497.95 each Price: $239.52 each
These are aftermarket replacement retainer clips for door locks. Replaces IH part# 897845R1 Loadstar 1952-1979
Door Lock Retainer Clip - 897845R1
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175...
cable - new old stock
Model(s): 1600, 1603, 1703, 173FC, 1800, 183FC, 1890, Binder 		369500c1, 1700291c1, 332623C91. New never been used Made in the 1970's by International Harvester. Fleetguard was the name on the IH in-house brand.
Air Filter element NEW OLD STOCK- 2 And 4 Barrel Carb New Old Stock
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Thermostat for a MV404 or MV446 Gas engine 1976-1981 Replaces IH Part 446437C1
180 Degree Thermostat for MV404 & MV446 Gas Engine
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175...
Price: $22.95 each Price: $179.34 each Price: $45.77 Price: $34.40 Each
This grommet holds your PCV Valve on to your valley pan on all V-8 engines
PCV Seal Grommet For IH V-8 Engines
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Rear window seal kit. This kit seals two windows that roll up and down in rear doors of crewcabs.
Rear Window Seal Kit - Loadstar
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		This is a kit to seal up two doors, either the front or rear, of a Loadstar crew cab.
Door To Body Seal Kit for Loadstar Trucks
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175... 		Aftermarket HEI Style Distributor for IH International Harvester 152, 196, 266, 304, 345, 392 V8 Engine - No Grinding to Fit and All New! ---CALL TO ORDER--- Choose 4cyl - 152, 196 or V8. 4cyl has an additional charge. Timing Control is only for a fuel injection system that is controlling the distributor/timing. If you are trying to use with a Holley Sniper you will need additional parts. YOU MAY GET RED OR BLACK ON CAP COLOR DEPENDING ON STOCK - CALL IF YOU WANT A SPECIFIC COLOR Just what the IH community was looking for, a quality aftermarket distribuitor for an afforable price! Unlike the D.U.I. distributor, these require no grinding to fit. ATTENTION USERS ORDERING A COIL - YOU NEED TO CHOOSE A COIL WITH 1 OHM RESISTANCE - CHOOSE OPTION FOR COIL Included is the distributor, and high-quality weatherpak pigtail to make removal of the distributor later a breeze! ---CALL TO ORDER---
NEW HEI Distributor for IH 152, 196, 266, 304, 345, 392 V8 Engine
Model(s): 1600, 1700, 1800
Price: $29.48 each Price: $224.73 each Price: $440.92 Kit Price: $759.95

Loadstarparts.com is not affiliated with International Motor Company. Loadstar is a registered trademark of International Motor Company. Any mention of Loadstar is for description purposes only.

Call to Order: 866-235-1979
Credit Card Badges
Privacy Policy | Legal Notices | Terms & Conditions | Shipping Policy

A division of ©2026 Pacific Supply Group.