Contact Us Gallery New & Updated Parts
Search
Cart 0 item(s): $0.00
   
Catalog
Axle Parts
Body Parts
Books & Information
Brakes
Clutch / Trans / Drive Line
Door Parts
Electric / Ignition
Emblems
Engine / Fuel System
Exterior
Gifts & Toys
Interior
NOS Parts
Seals
Service / Operators Manuals / Literature
Sheet Metal
Steering & Suspension
Used Parts
 

Output Shaft - New Old Stock
Model(s): 		Thread cutting nut to fasten emblems. 1/8\" stud size, 7/16\" washer diameter. They are also known as \"Speed nuts\"
Loadstar Emblem Thread Cutting Nut - Small & Large Size
Model(s): 		International Harvester Gear most likely fits Loadstar -NOS new in original IH box 289292c1
Loadstar IH Gear - NOS
Model(s): 		only one in stock. 350831C1
International Harvester Rubber Mount - New Old Stock 350831C1
Model(s):
Price: $279.49 each Price: $0.77 each Price: $178.65 each Price: $98.32 each
Used - mt 120, 135 This glass lens was used on 1900 cab-overs and 1910A to 2070A Trucks. The only one we have left is old and has a chip out of it.
Glass Back Up Light Lens - Used
Model(s): 		Great Stuff. Protect your wiring. When it makes contact with its self it fuses together and permanently. Available in red or black.
Self-fusing Tape For Loadstar
Model(s):
Bracket - New Old Stock
Model(s): 		New windshield seal. Known as a windshield retainer, it holds the windshield in the frame, it is the weatherstrip that goes around the windshield and keeps the rain and wind out. This is a new rubber, ready to install. This fits Loadstars 57-78, also binder series ac and bc, as well as travelcrews 1962-after We strongly recommend that you use a professional installer to put this in, both to ensure you do not break the glass, and to make sure you seal it completely and protect it against water getting between the rubber and the frame, causing future rustout of the frame. IH conventional cab Loadstar, Binder series AC and BC Travelcrew 62 and Up
Seal - Windshield - 1957-78 IH Loadstar cab Travelall, Series AC & BC
Model(s): 1600, 1603, 1610, 1700, 1703, 173FC, 173RE, 175...
Price: $47.20 each Price: $9.45 each Price: $59.03 each Price: $139.45 Each

Pedal Pad - Loadstar
Model(s): 1800 		Prevents bolts from freezing in the head/engine block. Set of 5 bolts works to mount one manifold. You will need two kits if you have a V-8. These are OEM copper-clad exhaust bolts used to attach exhaust manifolds to the cylinder heads. You need two long, two medium and one short one (for a total of five) per manifold. The copper discolors after exposure to high heat, but the copper cladding does not go away. The copper coating makes the bolts easy to remove even 40 years later. These are highly recommended. V8 engines will require two sets. I have personally removed at least one hundred IH exhaust manifolds and have never, NOT once broken a bolt. These were used at the factory and they really keep the bolt from fusing to the block.
Copper Clad Exhaust Manifold Bolt kit
Model(s): 		This is a 2/0 gauge Harness assembly that includes 3 hex serrated flange nuts and 1 charging post for 3/8" stud-type battery. Available in red and black
Battery Cable 7 Inch For Loadstar
Model(s): 		This was used on Loadstars from 1970 to 1977
Head Light Bezel Single Lens - NEW (NOS) Loadstar
Model(s):
Price: $28.26 each Price: $41.55 Set of 5 Price: $18.87 each Price: $112.04 each

Oil Sender - New Old Stock
Model(s): 		We typically gap spark plugs to .035 when installing, which is very close to the Champion factory gap. International Harvester Loadstar spark plug
Loadstar Spark Plug
Model(s): 1600, 1700, 1800
Wing Nut - Nos
Model(s): 		Turn signal retainer clip, retainer, light- new old stock. - 77585R1
Turn signal retainer clip, retainer, light- new old stock. - 77585R1
Model(s):
Price: $80.02 each Price: $6.28 Price: $46.87 each Price: $55.32
NOS Oil Gauge. This is a gauge used on L,R,S lines trucks of the 1950\'s. This one is brand new. It has been tested and works great. You will need to make sure that your gauge regulator is working.
International Harvester Gauge, Oil, White Lettering, NOS
Model(s): 		Drag Link Loadstar 1700.
Drag Link Loadstar 1700
Model(s): 		This is a used electronic ignition module. It was used with the 392 gas V-8 engines. 12volt negative ground International Harvester 484811-c2
Electronic Ignition For 392 IH V-8 Engine - Used
Model(s):
Cover - New Old Stock
Model(s):
Price: $155.10 each Price: $472.38 Price: $102.74 each Price: $137.18 each

Loadstarparts.com is not affiliated with International Motor Company. Loadstar is a registered trademark of International Motor Company. Any mention of Loadstar is for description purposes only.

Call to Order: 866-235-1979
Credit Card Badges
Privacy Policy | Legal Notices | Terms & Conditions | Shipping Policy

A division of ©2026 Pacific Supply Group.